Obloid
More tools

Wall Planter Generator

Loading the geometry engine…

Customize

Planter details

Size
Hanging slots

The slots cut through the rounded back tab. Hang the planter on screws or hooks; the slot width should clear the screw head.

Drainage
3MF color
205 x 148 x 223 mm with the tab
About 461 g in PLA, holds 3.4 L of soil
Prints upright with no supports

STL works in every slicer. The 3MF carries the color with it.

Printing notes

  • The bowl tapers outward as it rises and the back tab grows straight up from the back wall, so it prints upright on the bed with no supports.
  • The flat back and hanging tab share the same wall plane, so the whole back sits flush against the wall when mounted.
  • The default 14 mm slot clears most screw heads and small wall hooks. Use two slots for planters wider than about 220 mm so they cannot pivot.
  • For outdoor use print in PETG or ASA. PLA softens in direct summer sun and slowly gives way under load.
  • Set drainage to none if you keep a nursery pot inside and use the planter as a sleeve.

More free tools: Nameplate, Text to 3D, Spinning Top, or the tools hub.